Skip to content
How to install a beer tap onto a flash cooler

How to install a beer tap onto a flash cooler

Jul 27, 2023

Attached is a simple drawing to show a very basic installation of a single beer tap through a flash cooler. Links to some of the required parts listed below. ‍

  1. Gas Bottle (From your local supplier)
  2. Keg (Choice of keg from your local supplier)
  3. Keg coupler (Make sure that you get the correct connector for the beer that you will be using)
  4. Gas primary regulator
  5. Secondary gas regulator
  6. Fob detector
  7. Flash cooler
  8. Insulated pipe
  9. Flow controller
  10. Font and tap

You would also require 1 x John Guest 3/8 plug fitting for the side of the secondary regulator, 2 x 3/8 John Guest equal elbow fittings for the attachment to the flash cooler. Also, the required product and gas pipe can be found HERE.

basic installation of a single beer tap diagram

Andrew Pottinger

Leave a comment

Please note, comments must be approved before they are published

Draught drinks installation and repair

Beer taps, coolers and gas equipment installed, maintained and repaired.

Our service area includes the following; Aylesbury, Battle, Barwell, Brighton, Bexhill, Birmingham, Bournemouth, Bognor Regis, Chichester, Crawley, Croydon, Dartford, Derby, Eastbourne, East Grinstead, Gatwick, Guildford, Hailsham, Hastings, Haywards Heath, Horsham, Horley, Leicester, Lewes, Littlehampton, Leeds, London, Maidstone, Milton Keynes, Kingston upon Thames, Newhaven, Nottingham, Northampton, Oxford, Portsmouth, Reading, Romsey, Seaford, Slough, Southampton, Tamworth, Tonbridge, Tunbridge wells, Worthing, Winchester and surrounding. Supplying brewery dispense technical services to Berkshire, Hampshire, Kent, Sussex and Surrey.